The WF series frost top provides the most attractive way of displaying your pre-plated cold foods. The unit frosts over quickly, providing a bed of snow—the perfect setting for salads and desserts. The drop-in pan can be installed in virtually any counter and can be provided as fully self-contained—just plug it in and turn it on, or remote, where there’s a need to locate the compressor at a different location.
The pan is fully insulated for maximum efficiency and energy savings, and is provided with a factory applied gasket so that it can be installed in the finest wood fixtures without marring the counter top. The frost top is constructed of stainless steel and stands 1″ above the counter top for an eye-catching display. When turned off, the condensate melts into the full perimeter gutter, sloped to a 1/2″ drain.
TOP: Constructed of 14 gauge, type 304 stainless steel, die stamped with a raised perimeter bead. There shall be a solid vinyl gasket under the beaded edge to form a seal to the counter top, thus preventing seepage or marring of the counter top.
FROST TOP: Constructed of 14 gauge, type 304 stainless steel, one piece construction, all welded, ground and polished to a uniform finish. The top is formed to stand 1″ above the counter top and is provided with a 1/2″ full perimeter gutter to collect melted condensate; a 1″ IPS drain is provided. The frost top has copper tubing firmly soldered to the exterior bottom.
INSULATION: The pan is fully insulated with high density fiberglass and polystyrene, 1-1/2″ thick, and enclosed with an 18 gauge galvanized steel outer liner. The entire unit is removable without the use of tools.
REFRIGERATION SYSTEM (WCM SERIES ONLY): The compressor housing shall be fabricated from 14 gauge galvanized and bolted to the base of the unit. A fully self-contained condensing unit provided with a hermetically sealed compressor. The system is fully charged with CFC-free refrigerant cap tube, filter drier, and on/off switch provided—and ready to operate.
NOTE: Proper ventilation must be provided in counter.
ELECTRICAL (WF SERIES ONLY): The unit will be wired for 15 amp, 120 volt, single phase operation with an on/off switch and pilot light. A 6′-long, 3-wire cord and plug (NEMA 5-15P) will be provided.
*Model Shown: WF-4 – Not representative of final product