The WCM-BT series cold pan is the most efficient refrigerated cold food display available anywhere. The traditional cold-wall system is replaced by a forced air evaporator, enabling precise temperature control and maximum cold transfer to your food product. The drop-in pan can be installed in virtually any counter and is fully self-contained—just plug it in and turn it on.
The pan is fully insulated for maximum efficiency and energy savings, and is provided with a factory applied gasket so that it can be installed in the finest wood fixtures without marring the counter top. The pan is constructed of stainless steel and is provided with a 3/4″ stainless steel drain. The forced air evaporator drains into a condensate evaporator.
TOP: Constructed of 18 gauge, type 304 stainless steel, die stamped with a raised perimeter bead. There shall be a solid vinyl gasket under the beaded edge to form a seal to the counter top, thus preventing seepage or marring of the counter top. Embossed mounting lugs are provided along the inner surface of the top to hold a full set of removable separator channels in place.
LINER: The inner liner shall be 18 gauge, type 304 stainless steel, one piece construction, all welded, ground and polished to a uniform finish. All corners are coved with a minimum 1/4″ radius. A 3/4″ dia. drain with strainer, 4″ PVC nipple, and valve is provided.
INSULATION: The pan is fully insulated with high density polystyrene, 1″ thick on all sides, 2″ thick on the bottom and enclosed with a 22 gauge galvanized steel outer case.
REFRIGERATION SYSTEM: The compressor housing shall be fabricated from 14 gauge galvanized and bolted to the base of the unit. A fully self-contained condensing unit is provided with a hermetically sealed compressor and a thermostat control. The system is also provided with a forced air evaporator for even temperature throughout the pan that drains into a condensate evaporator pre-wired in the unit. Automatic defrost system is provided. The system is fully charged with CFC-free refrigerant and ready to operate.
NOTE: Proper ventilation must be provided in counter.
ELECTRICAL: The unit will be wired for 15 amp, 120 volt,
single phase operation with an on/off thermostat switch and pilot light. A 6′-long, 3-wire cord and plug (NEMA 5-15P) will be provided.
*Model Shown: WCM-BT-4 – Not representative of final product