Top: Constructed of 18 gauge, type 304 stainless steel, die stamped with a raised perimeter bead. There shall be a solid vinyl gasket under the beaded edge to form a seal to the counter top, thus preventing seepage or marring of the counter top.
Liner: The inner liner shall be 18 gauge, type 304 stainless steel, one piece construction, all welded, ground and polished to a uniform finish. All corners are coved with a minimum 1/4″ radius on the horizontal edges and a minimum 3/4″ radius on the vertical edges. The liner has copper tubing firmly soldered to the exterior sides and bottom. The unit is provided with an all stainless steel, insulated, hinged, lift-off lid, with plastic coated pulls.
Insulation: The unit is fully insulated with high density polystyrene, 2-1/2″ thick on all sides, and enclosed with a 22 gauge galvanized steel outer liner.
Refrigeration System: The compressor housing shall be fabricated from formed angles and bolted to the base of the unit. A fully self-contained condensing unit is provided with a hermetically sealed compressor and a thermostat control. The system is fully charged with CFC-free refrigerant and ready to operate.
Note: Proper ventilation must be provided in counter.
Electrical: The unit will be wired for 15 amp, 120 volt, single phase operation, with an on/off thermostat switch and pilot light. A 6′-long, 3-wire cord and plug (NEMA 5-15P) will be provided.
