Body: Double wall constructed with a 20 gauge, type 304 stainless interior liner, with coved corners. Exterior wall is 22 gauge galvanized steel, with an 18 gauge stainless steel facia. The body is filled with 1″ of high density polystyrene insulation on all sides. The interior of the body is provided with a removable slide assembly to accommodate 12″ x 20″ pans. A 2-1/2″ dial thermometer is mounted in the facia.
Doors: Doors are double wall constructed of 18 gauge, type 304 stainless steel, fully insulated with high density polyurethane and provided with edge mounted, chrome plated hinges and a slam action latch. Doors are complete with a moisture-proof gasket.
Refrigeration System: The compressor housing is integral with the body of the unit and provided with a removable, louvered access panel. A fully self-contained condensing unit is provided, with a hermetically sealed compressor and a thermostat control. The system is also provided with a forced air evaporator for even temperature throughout the base and drains into a condensate evaporator, pre-wired in the unit. The system is fully charged with CFC-free refrigerant and ready to operate factory set, between 35 and 45 degrees.
Note: Proper ventilation must be provided in counter
Electrical: The unit will be wired for 15 amp, 120 volt, single phase operation. A 6′-long, 3-wire cord and plug (NEMA 5-15P) will be provided.
